Low Level Sensor Float Switch

Product Information

This tiny 12 volt float switch can easily be installed in just about any Alcohol & Water tank.  Installation is just drilling a hole in the bottom of your tank, and then feeding the switch through from inside the tank. Just use the wires to guide you to your drilled hole, and then pull the 14 inch wires from the outside to seat the switch in place.  A rubber washer is included for an easy watertight seal, no messy glue is required.  You install this between the ground source and your indicator light.  This switch can be open or closed in either the up or down position.  When delivered, the switch will turn on a light when the water level drops too low, OR, if you rotate the float, the switch will then leave the light on when there is water in the tank and then go out when the tank empties.  The choice is up to you.   All that is needed for installation is a 3/8" drill bit, everything else can easily be done by hand.

Price: $19.99

• Tell a Friend